Yamaha MBK X-MAX 300 2017 Service Manual page 370

Fault code No.
Item
1 Locate the malfunction.
2 "01" is indicated in diagnostic
mode (Code No. 60). EEPROM
data error for adjustment of CO
concentration.
3 "11" is indicated in diagnostic
mode (Code No. 60). EEPROM
data error for ISC (Idle Speed
Control) learning values.
4 "12" is indicated in the diagnos-
tic mode. (Code No. 60) EE-
PROM data error for A/F control
learning values.
5 "14" is indicated in the diagnos-
tic mode. (Code No. 60) EE-
PROM data error for tire
diameter learning values.
P062F
EEPROM fault code number: an error is detected while reading or
writing on EEPROM.
Execute the diagnostic mode.
(Code No. 60)
00: Go to item 6.
01: Go to item 2.
11–12: Go to item 3.
Change the CO concentration,
and rewrite in EEPROM.
Refer to "ADJUSTING THE EX-
HAUST GAS VOLUME" on
page 3-8.
After this adjustment is made,
turn the main switch to "OFF".
Turn the main switch to "OFF".
Turn the main switch to "OFF".
Turn the main switch to "OFF".
8-65
FUEL INJECTION SYSTEM
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recover" → Go to
item 7 and finish the service.
Condition is "Malfunction" →
Repeat item 1.
If the same number is indicated,
go to item 6.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recover" → Go to
item 7 and finish the service.
Condition is "Malfunction" → Ex-
ecute the diagnostic mode
(Code No. 67) and then repeat
item 1.
If the same number is indicated,
go to item 6.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recover" → Go to
item 7 and finish the service.
Condition is "Malfunction" → Ex-
ecute the diagnostic mode
(Code No. 87) and then repeat
item 1.
If the same number is indicated,
go to item 6.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recover" → Go to
item 7 and finish the service.
Condition is "Malfunction" → Ex-
ecute the diagnostic mode
(Code No. 87) and then repeat
item 1.
If the same number is indicated,
go to item 6.