Agilent Technologies SD-1 User Manual page 52

4
Using the SD-1 Solvent Delivery Module
Operation
Remote Control
This section provides a brief introduction to remote control by your
instrument control software. For complete information you should also read
the instrument control software manual.
1 Connect the Agilent SD-1 Solvent Delivery Module to your computer with
2 Connect the AC power cord and the external contacts panel (see Agilent
3 Press the ~ key to open the Special display.
4 Press the DOWN ARROW key to open the SETUP display.
5 Press the RIGHT ARROW to move the cursor on the DEVICE # field.
6 Set the DEVICE # as desired by scrolling with the UP or DOWN ARROW keys.
If you have two pumps, only one of the built-in CIM (Control Interface Modules) should be
N O T E
used if required. Set the second CIM ID number to – –, first enter a 63, and then press the
DOWN ARROW key. Internal CIM ID number is set only when the internal CIM is used to
start data collection or another instrument.
7 When you have set DEVICE # for all devices in your system, refer to your
52
the serial interface cable (see Agilent SD-1 Purification Solution - System
Manual (G9302-90301)).
SD-1 Purification Solution - System Manual (G9302-90301)).
For your instrument control software to control your pumps, each device
must have a unique DEVICE # ID number. The ID numbers are shown on the
bottom line, in this case PUMP ID is 1 and CIM ID is 8.
Figure 31 SETUP display
instrument control software manual for details on how to use remote
operation and how to set up additional electrical connections, depending
upon your particular system requirements.
For example connections for wavelength control of a detector, fraction
collector contacts out, and so forth.
SD-1 Solvent Delivery - User Manual