Agilent Technologies SD-1 User Manual page 19

• UNITS: Pressure units psi, bar or MPa
• ANALOG PRESSURE MONITOR: ON or OFF;
When controlling detector wavelength, the instrument control software may
override this control. The SD-1 may need to be switched off and on to release
the override.
Special displays
Pressing the ~ key opens the Special display, to access the SETUP and SERVICE
LOG menus.
SETUP Display
Figure 10
Figure 11
SD-1 Solvent Delivery - User Manual
Pressure below which the pump will stop — must go for about 10 s then stay
below for 0.5 s to stop
Sends an analog signal (1000 psi/V) to an external pressure monitor, if the
instrument control software is not controlling the detector wavelength
through the ANALOG OUT contacts on the SD-1.
Special display
SETUP display
1
Introduction
Control
19