Agilent Technologies SD-1 User Manual page 16

1
Introduction
Control
Table 3 Specific cursor functions
Cursor Name
- - NUMERIC
ENTRY
CURSOR
↓↑ SCROLL
CURSOR
?? DUAL-MODE
CURSOR
| | MENU
CURSOR
N O T E
The following are not cursors, but are described here for clarity.
* ASTERISK
←→ LEFT-RIGHT
ARROWS
Home Display
The Flow display is also the home display. This display shows when the SD-1
starts up and can be accessed at any time by pressing the FLOW button. The
top line of the display always shows current flow rate and pressures.
16
Function
Used for numeric entry only. Values entered or edited while the cursor is flashing are
temporary until accepted by pressing the ENTER key, the RIGHT ARROW key, the LEFT
ARROW key, or the RUN key. If the edited value is not accepted by pressing one of the
above keys, or cancelled by pressing the CLEAR key, the parameter reverts to its previous
value after 60 seconds.
Used when there is a preset list of choices. Pressing the UP ARROW or the DOWN
ARROW with this type of cursor is displayed scrolls up or down through the preset choices.
Used when there is a preset list and numeric entry. Used when the value can be set either
by numeric entry or by scrolling through a preset list of choices, as described above.
Used when the selection is a menu. Pressing the DOWN ARROW or the ENTER key with
this type of cursor displays the next level of the menu.
Used to show cursor position (for accessing HELP) when the parameter in question is a
status indicator and cannot be edited.
These indicators are used at the right or left edge of the display to indicate that more
information can be seen by pressing either the RIGHT or LEFT ARROW key.
SD-1 Solvent Delivery - User Manual