References To The Legislation; Description Of Symbols; Preparation By The Purchaser - Sanremo F18 SB Instruction Booklet

General rules and warnings
- IN DOUBT, ALWAYS REQUEST THE INTERVENTION
OF SPECIALIZED PERSONNEL.
- ELECTRICAL/ELECTRONIC OR MECHANICAL
TAMPERING WITH THE MACHINE BY THE USER
AND NEGLIGENT USE OF THE MACHINE WILL
WAIVE ANY LIABILITY FOR THE MANUFACTURER,
MAKING THE USER THE ONLY ONE RESPONSIBLE
BEFORE INJURY PREVENTION AUTHORITIES.

1.2 REFERENCES TO THE LEGISLATION

- The machine and its safety devices have been
manufactured in compliance with the standards
listed in the declaration of conformity.

1.3 DESCRIPTION OF SYMBOLS

- Many accidents are caused by insufficient
knowledge and failure to apply safety rules during
operation and maintenance of the machine.
- In order to avoid accidents, read, understand and
follow all cautions and warnings contained in this
manual and those shown on the labels applied to
the machine.
- To identify the safety messages included in this
manual, the following symbols have been used:
Electricity hazard
General hazard or miscellaneous
Heat hazard (burns)
Danger of damaging the machine
To identify operations that must be performed
exclusively by a specialised technician, we used the
following symbol:

1.4 PREPARATION BY THE PURCHASER

a. Preparation of the installation area
- The purchaser must prepare a support floor for the
machine as described in the installation chapter.
Electrical preparation
b.
- The power supply system must comply with current
national regulations of the area and must be fitted
with an efficient grounding system.
- Position an omni-polar disconnecting device on the
power supply line, upstream of the machine.
The power supply cables must be
sized according to the maximum
current required by the machine so
that the total voltage drop under full
load is less than 2%.
9
F18 SB