Sanremo F18 SB Instruction Booklet page 42

F18 SB
HOT WATER DOSE PROGRAMMING
• It is possible to save two different hot water
doses. To store dose "1", press button (E) for
more than 10 seconds and check that the LED
changes from steady to flashing. Within 30
seconds press button (4) associated with the
tea dose once to store dose "1". The following
screen will be displayed:
• When the desired quantity has been reached,
press button (4) again to stop dispensing.
• If you wish to program dose "2", follow the
same procedure by pressing button (4) twice
quickly.
• After 30 seconds without using any button, the
dose programming stage will be quitted.
PROGRAMMING FOR AUTOSTEAMER STEAM
TEMPERATURE SIMULATION
• Milk frothing (button 1) and drink heating
(button 2) can be programmed independently
to respectively froth milk or heat a drink with
two different temperatures (both by default set to
60°C / 140°F).
PROG.
DOSE 1
15 s
PROG.
DOSE 2
15 s
• Before you start programming one of the two
buttons, prepare the jug with milk or drink you
want to heat under the wand.
• Insert a thermometer inside the jug if you want
to measure the product temperature.
• To program the operating temperature of milk
frothing function, enter the mode pressing button
(1) for more than 5 seconds. The following
screen will appear on the display with the
seconds counter indicating the time in progress:
• Alternatively press button (2) for more than 5
seconds for heating only. The following screen
will appear on the display with the seconds
counter indicating the time in progress:
• Once the desired temperature has been
reached, press the previously pressed button
again. The new temperature value is stored.
• After 10 seconds without using any button, the
temperature programming stage will be quitted.
42
Programming
PROG.
MILK FROTHING
00 s
PROG.
MILK HEATING
00 s