Sanremo F18 SB Instruction Booklet page 43

Programming
It is possible to adjust the amount of inlet air into
the Autosteamer to vary the degree of milk frothing
by acting on the "Y" regulator positioned under the
machine.
_
+
Turn clockwise (+) to increase the amount of air in
the emulsion.
MACHINE SWITCHING ON/OFF
To switch off the machine, using unit 1, press button
(E) and then button (C) while keeping button (E)
pressed. All the button panels and the display switch
off; to switch the machine on again press button (C)
of unit 1.
TECHNICAL USER MENU
To access the technical user menu, in ON condition
press button (E) of unit 1 for at least 15 seconds:
once the display shows the message "DOSE
PROGRAMMING" continue to hold button (E)
pressed. The following items are displayed in
sequence:
• 1) Cup heating plate,
• 2) LED bar.
• 3) ECO mode.
• 4) Programming coffee doses.
• 5) Pre-infusion enabling
• 6) Setting of ON/OFF time for pre-infusion of
single doses.
• 7) Setting of ON/OFF time for pre-infusion of
double doses.
• 8) Enabling of user "Flush" signal
• 9) Setting of clock and programmed switching
on.
Y
• 10) Global counters.
• 11) Unit automatic washing
• 12) Menu exit
Use buttons (C) and (D) to go backwards/forwards
in the user menu items, to enter the selected item,
press button (E).
Once in the menu, press (A)/(B) to decrease/
increase the value if there is a numerical field
to be modified or to enable/disable a function.
After making your choice, press (E) to return to the
technical user menu or (C) or (D) to confirm and
move on to the previous or next function. If you
pause for more than 60 seconds on a selected
parameter without taking any action, you will
automatically exit the menu. On each item of the
menu, only the buttons actually useful and necessary
to modify the values of the parameter under
examination will be lit.
LED AND CUP HEATING PLATE ENABLING
You can enable the LEDs and the cup heating plate.
Go to the technical menu and enter the cup heating
plate menu by pressing button (E). The following
screen will be displayed:
(ENABLED-DISABLED)
If you want to modify the parameter (display
enabled or disabled) you must act on buttons (A)
(<) or (B) (>). Once enabled, it is possible to set
the power value expressed in % from a minimum of
20% to a maximum of 100% by pressing the (A) (-)
or (B) (+) buttons. It is possible to enable/disable the
cup heating plate without accessing the user menu
using unit 2 by pressing button (E) and then button
(B) while keeping button (E) pressed; activation of
this mode is indicated by the icon on the TFT (cup
heating plate) turning on. After the last parameter
has been set, press
button (D) to move on to the LED lighting setting.
Press button (E) to enter the menu. The following
43
HEATING CUP
F18 SB