Sanremo F18 SB Instruction Booklet page 46

F18 SB
XXX = ON / OFF
YY = idle time of the unit in minutes after which
the button (E) of the unit concerned provides the
indication.
If you want to modify the parameter related to the
enabling/disabling of the item, use buttons (A) (<) or
(B) (>). Default value OFF. By pressing button (A) (-)
or (B) (+) you can change the unit inactivity waiting
time. Press (E) to save and return to the menu. When
the set time expires (valid for all units), button (E)
of the unit under examination makes two ON/OFF
flashes every 90s ("FL" on group display). When the
button (E) blinks press it to perform the Flush.
CLOCK SETTING
After the "Flush" menu you will find the clock setting
menu. To enter the item, press the button (E). The
following screen will be displayed:
CLOCK ADJUST.
hh.mm xxxxxx
HH = current time (0...23)
MM = current minute
XXX = day of the week
If you want to change the parameter you have to
move with the button (C) (<) or (D) (>) and with
button (A) (-) or (B) (+) you change the values.
After the last parameter has been set, press button
(E) to move on to the automatic switch-on setting.
AUTO ON/OFF/ECO SWITCHING ON/OFF
It allows the definition of the automatic switching-
on/off times of the machine and the weekly closing
days. The following screen will be displayed:
As an alternative to the OFF mode, it is possible to
set the ECO mode that keeps the machine active,
but at a lower SETPOINT.
They are programmed in the following order:
- switching on time (AAA = ON)
- switching on minute (AAA = ON)
- switching off time/ECO (AAA = OFF/ECO)
- switching off minute/ECO (AAA = OFF/ECO)
- days off
To switch between them, press button (C) (<) or (D)
(>).
It is possible to set just one switching on and one
switching off and they are valid for all the days of
the week except for the days off. If you do not wish
to have automatic switching on or off, go to the
programming of the corresponding time and press
(A) (+) or (B) (-) and set the value "-.- - -" visible on
the display until one of the two screens appears on
the display:
- if the switching on is disabled, the switching off
and the day off remain automatically disabled;
pressing (E) skips the relative settings and goes
directly to the next parameter. Switching on and
off can therefore only be done manually using the
procedure described in the previous paragraph.
- If switching on is enabled, pressing (E) allows
passing to the switching off setting.
- Once the switching off has been set, press (E) to
access the days off menu.
46
Programming
AUTO ON-OFF
yyyy: hh mm
AUTO ON-OFF
on: -- . --
AUTO ON-OFF
eco: -- . --