Sanremo F18 SB Instruction Booklet page 44

F18 SB
screen will be displayed:
(ENABLED-DISABLED)
If you want to modify the parameter (display
enabled or disabled) you must act on buttons (A) (<)
or (B) (>), confirm with (E). It is possible to enable/
disable the LED activation without accessing the user
menu using unit 2 by pressing button (E) and then
button (D), always keeping button (E) pressed.
ECO MODE ENABLING
After the settings concerning the LED bar, pressing
again the button (D) allows moving to the enabling
of the "ECO MODE". To enter the item, press the
button (E).
(ENABLED-DISABLED)
If you want to modify the parameter (display
enabled or disabled) you must act on buttons (A) (<)
or (B) (>), confirm with (E). Activation of this mode
is indicated by the lighting up of the icon on the TFT
(green leaf).
LED BAR
ECONOMY
The operation is structured as follows:
Phase 1: after 1h30' of missing coffee or hot water
dispensing, the machine switches to economy
mode with steam boiler temperature fixed at 110°C
(230°F).
Phase 2: after 3 more hours, it brings the boiler
temperature to 100°C (212°F).
Phase 3: after another hour, the heating is brought
to 60°C (140°F) alternating heating phases up to
80°C (176°F). In this phase the LED bar and cup
heating plate are switched off.
It will not be possible to make coffee/hot water/
steam and the LEDs will be off while the LED (C) of
unit 1 remains on and when pressed it allows you
to exit the ECO mode. Even if it is disabled from the
user menu, it is possible to set the machine directly
to ECO phase 1 by repeating the pressing sequence
of button (E) twice and then button (C), always
keeping button (E) pressed. The number on the right,
indicated by the arrow, indicates the current ECO
phase.
It is possible to interrupt the Energy Saving cycle
before it ends and re-establish the optimal operating
conditions by pressing button (C) of unit 1.
VIEWING AND EDITING DOSES
After the settings for the economy mode, press
button (D) again to display/change the coffee
doses in ml. To enter the menu details press (E),
while pressing (D) to go to the next parameter.
44
Programming