Advertisement
Quick Links
Disclaimer: Installation must be performed by professional technician. Improper installation can void warranty, permanently damage equipment and/or present burn
& electrical hazard to installer/user. Consult with local municipality for official electrical and plumbing codes/guidelines.
Consult user manual for expanded installation, operation, and safety guidelines.
Dimensions
2 Group
Water Requirements
Electrical Requirements
2 Group
•
Volts: 220 (voltage range of 208-240) 60Hz
•
Single phase / 3 wire (2 hot + 1 ground)
•
Watts: 3200
•
Amp draw: 15A
•
Receptacle / plug: NEMA 6-30
•
Plug included
Sanremo F18SB Installation & Quick Start Guide
•
Volts: 220 (voltage range of 208-240) 60Hz
•
Single phase / 3 wire (2 hot + 1 ground)
•
Watts: 5650
•
Amp draw: 24A
•
Receptacle / plug: TBD
•
Plug included
3 Group
3 Group
Receptacle & Plug Configuration
Advertisement
Related Manuals for Sanremo F18SB
Summary of Contents for Sanremo F18SB
- Page 1 Sanremo F18SB Installation & Quick Start Guide Disclaimer: Installation must be performed by professional technician. Improper installation can void warranty, permanently damage equipment and/or present burn & electrical hazard to installer/user. Consult with local municipality for official electrical and plumbing codes/guidelines.
- Page 2 Connection & Counter Hole Diagrams 3” hole in counter recommended for passage of electrical cord & water/drain lines. Counter hole placement recommended to be center of machine and 12.5” inward from edge of the drip tray. First start (boiler fill) procedure...
- Page 3 Display readout STEAM BOILER TEMPERATURE OR PRESSURE (USER CAN SET) STEAM BOILER WATER LEVEL Pump adjustment Prepare a portafilter with coffee at the desired dose/grind calibration and insert into the group. Turn group on by selecting the continuous (SR logo) button, insert stubby screwdriver into pump hole and adjust WHILST the group is extracting the coffee.
-
Page 4: Volumetric Programming
Water mix valve located near water pipe connection Group Volumetric Programming • Press and hold Sanremo logo (continuous) button on group 1 (left most group) until touchpad LED’s begin flash and pressure display reads ‘DOSES SETTING SELECT DOSE IN 30 S’. -
Page 5: Programming Menu Options
Accessing Programming Menu • Press and hold Sanremo logo (continuous) button on group 1 (left most group) until ‘HEATING CUP’ is read on pressure display. • If continuous button is released when display reads ‘DOSES SETTING SELECT DOSE IN 30 S’,... -
Page 6: Warranty Terms And Conditions
SANREMO TSD (Technical Service Iron: 0 ppm Department) will be replaced. SANREMO Srl has the right to make changes to its products at any Water levels outside of these parameters can void warranty. Consult with a water filtration professional for water testing time necessary for technical and / or aesthetic reasons, reserving and recommended systems.