Track Thickness; How To Create A Route With Past Track (Follow Track) - Furuno NAVNET TZ2 TZTL12F Operator's Manual

2. CHART PLOTTER
Note 2: For [Depth], [SST Range], [SST Variation], and [Speed], you can change
the threshold amount for each color. Tap a threshold value to display the software
keyboard. Set the value, then tap [].
10. Tap the close button on the title bar to close the menu.
On the chart plotter screen
1. Tap a section of track to display the pop-up menu.
2. Tap [Color].
3. Tap a color.
2.11.5

Track thickness

You can set the thickness of the track. If you are following the same track many times,
you can show the track in the thinnest width to prevent overlapping of track.
1. Open the home screen, then tap [Settings]→[Ship & Track].
2. Drag the slider at [Track Thickness] to set the level. (The thickness can also be
set with the software keyboard. Tap the keyboard in the [Track Thickness] field
then enter desired thickness.)
3. Tap the close button on the title bar to finish.
2.11.6

How to create a route with past track (follow track)

You can use past track to create a route. The route is saved to the routes list.
1. Tap the past track to use to create a route to show the pop-up menu.
2. Tap [Follow Track].
A route is created with past track. Points are automatically entered and arrows
(see "1" in the illustration on the next page) point in the direction of travel.
3. Enter route name, then tap [].
2-22