How To Set Route Density; How To Follow Routes; How To Follow An On-Screen Route - Furuno NAVNET TZ2 TZTL12F Operator's Manual

5.9

How to Set Route Density

If you display all your routes, the screen can become cluttered with routes. To prevent
this, set route density as shown below to limit the number of routes to show.
1. Open the home screen, then tap [Settings]→[Points]→[Routes Density] to show
the following options menu.
2. Tap desired route density. [Low] is the lowest route density, and [Full] displays all
routes.
3. Tap the close button on the title bar to close the menu.
5.10

How to Follow Routes

Before you follow a route, make sure that the path to the route is clear. Make sure to
zoom your chart to check for hazards that do not appear on a smaller scale.
5.10.1

How to follow an on-screen route

1. Tap a route leg of the route to follow to show the pop-up menu.
2. Tap [Start Nav].
Own ship icon
(current position)
Arrows point in direction
Arrival area
to follow route
Set course to next point
(light-purple)
5. ROUTES
Route leg (purple line)
XTE line
Red: port
Green: starboard
5-13