Table of Contents
Advertisement
2.10.5
Anchor watch alarm
The anchor watch alarm tells you that your ship has moved a distance greater than
the set value when the ship must not be moving.
Your ship's position where you
start the anchor watch alarm.
1. Tap [Anchor Watch Alarm Value] to display the software keyboard.
2. Set the value, then tap [].
3. Turn on [Anchor Watch Alarm] in the [Alarm] menu.
4. Tap the close button on the title bar to finish.
A green circle, with an anchor symbol at its center, marks the anchor watch zone. If
the boat nears the edge of the circle, the message "Anchor Watch Warning" (yellow
status bar) appears in the status bar and the circle turns yellow. If the boat goes out
of the circle, the message "Anchor Watch Alarm" (red status bar) replaces "Anchor
Watch Warning" and the circle turns red and flashes.
To reset the anchor watch alarm zone (when your boat goes out of the zone), tap the
[Reset] icon on the navigation bar. A message asks you if you are sure to reset the
anchor watch alarm. Tap [Yes] to reset the zone.
To move the zone or adjust the zone radius, tap the anchor symbol or the red circle to
show the pop-up menu. Tap [Edit Anchor Watch]. To move the zone, drag the position
icon. To adjust the radius of the zone, drag the zone size icon. Tap [End Editing] at the
top right corner to finish.
Position icon:
Change the position
of the zone.
To deactivate the alarm, select [OFF] at step 1 in the procedure. The alarm can also
be deactivated from the navigation bar. Tap [STOP]. You are asked if you are sure to
stop the anchor watch alarm. Tap [Yes] to deactivate the alarm.
The alarm can also be activated from the chart plotter display. Tap the own ship icon
to show the pop-up menu. Tap [Anchor Watch Alarm] to activate the alarm.
If the two finger tap function (short or long) is set for [Anchor Watch Alarm], the anchor
watch alarm can be toggled on or off by tapping the screen with two fingers (see
section 1.8). When the screen is tapped, the message "Anchor Watch Alarm enabled"
(or disabled) appears for three seconds.
Alarm
setting
2. CHART PLOTTER
: Alarm area
Zone size icon:
Adjust the radius of
the zone.
2-15
Advertisement
Table of Contents
Troubleshooting
