Table of Contents
Advertisement
7. FISH FINDER (SOUNDER)
7.3.3
Zoom displays
Zoom mode expands selected area of the single frequency picture. Two modes are
available: bottom lock and bottom zoom.
How to activate, deactivate a zoom display
Open the Layers menu. Tap [Bot. Lock], [Bot. Zoom] or [Marker Zoom] at [Display
Mode], To quit the zoom display and go to the single frequency display, open the Lay-
ers menu, then tap [Single Freq] at [Display Mode].
Bottom lock display
The bottom lock display provides a compressed normal picture on the right half and a
7 to 400 feet (2 to 120 meter) wide layer in contact with the bottom is expanded on the
left half. This display helps you separate the fish near the bottom from the bottom
echo. You can select the bottom lock range with [Bottom Lock Range Span] in the
[Settings]→[Fish Finder] menu.
Zoomed school
of fish
Bottom zoom display
The bottom zoom display expands the bottom and the fish near the bottom according
to the zoom range selected on [Zoom Range Span] in the [Settings]→[Fish Finder]
menu. This display helps you find the density of the bottom. A short echo tail normally
indicates a soft bottom (sand bottom, etc.). A long echo tail indicates a hard bottom.
Bottom
7-4
Bottom lock display
m
20.5
15.3 °C
Gain 50
BL
200 kHz
200 kHz
Bottom shown as a straight line
Bottom zoom display
m
20.5
15.3 °C
Gain 50
BZ
200 kHz
Single freq. display
Single freq. display
Zoom marker
School of fish
Zoom marker
This area zoomed
and displayed on
left 1/2 of screen.
Zoom marker
automatically
follows change in
depth.
Advertisement
Table of Contents
Troubleshooting
