How To Display The Fish Information; How To Set The Minimum Size Of Accu-Fish ™ Symbols; Rezboost - Furuno NAVNET TZ2 TZTL12F Operator's Manual

7.14.4

How to display the fish information

Tap a fish symbol to display the information (size, depth, bearing and range) about the
fish.
7.14.5 How to set the minimum size of ACCU-FISH
If you are in an area where there are many fish, the screen may become congested
with ACCU-FISH
symbols.
1. Open the [Fish Finder] menu.
2. Tap [ACCU-FISH Minimum Size] to show the software keyboard.
3. Enter the minimum size (0 to 79.98 (inch)), then tap .
4. Tap the close button on the title bar to finish.
7.15

RezBoost

With connection of a RezBoost
proved. In the example below, it is difficult to distinguish fish from the bottom. With [En-
hanced] RezBoost
RezBoost
Note: To enable RezBoost
[TZT2BB] as applicable.
1. Open the Layers menu.
2. Set [RezBoost] to [Enhanced].
To deactivate RezBoost, select [Standard] at step 2 in the procedure.
Fish-It
™
symbols. To prevent this, you can set the minimum size for the
™
™
™
, however, fish near the bottom are clearly seen.
Enhanced mode
™
is available with the transducers listed in Appendix 3.
™
, set the fish finder source as [TZTL12F], [TZTL15F], or
capable transducer, echo resolution can be im-
Standard mode
7. FISH FINDER (SOUNDER)
™
symbols
7-17