Table of Contents
Advertisement
4. POINTS, BOUNDARIES
4.15.4
How to use the NAVpilot to steer to a point
When you select a point to follow and a FURUNO NAVpilot is engaged and activated
in the system, the message "DO YOU WANT TO NAVIGATE USING THE NAVPI-
LOT?" appears. Tap [Yes] to have the NAVpilot steer the vessel, then the NAVpilot
automatically goes into the NAV mode.
For the NAVpilot-300, you are asked to select a navigation mode. Select [Precision]
or [Economy]. ([Cancel] stops the NAV mode.) After selecting a mode, the NAVpilot-
300 automatically goes into the NAV mode.
Precision mode: Keeps XTE within 0.01 NM
Economy mode: Keeps XTE within 0.03 NM
Note: The example figure below shows the NAVpilot's display in the NAV mode. See
section 2.13.3 for details.
4.15.5
How to display the point information for the active goto point
1. Tap the yellow line that runs between own ship and the
Goto point to show the pop-up menu. Note that the pur-
ple line can also be tapped to show the pop-up menu.
2. Tap [Detail] to show the [Route Detail] window.
3. Tap the close button on the title bar to finish.
Description of Route Detail window
Colored vertical bars: The bars at the left edge of the screen are colored according
to the status of the Goto point.
Gray: Starting point
Yellow: Goto point
4-22
Bow
Point 1
Turn/Setting
Appears when NAVpilot-300
is engaged.
Advertisement
Table of Contents
Troubleshooting
