Using Profiles - 3DHISTECH Pannoramic 250 FLASH III User Manual

Pannoramic 250 FLASH III 3.0.2 User's Guide

6 Using Profiles

Saved profile settings cannot be applied if using a different type of
Pannoramic® scanner.
If you want to scan a group of slides, it is advised to save your settings previously in a profile and
continue scanning in Automatic mode. You can save the following settings in a profile:
Scan Mode
Brightfield
•
Fluorescent
•
Scan Options
Focus frequency (in Fluorescent mode)
•
Focus frequency (in Brightfield mode)
•
Compression procedure
•
Use of a fixed compensation image (in Brightfield mode – ON/OFF)
•
Use of Save focus quality (ON/OFF)
•
Use of stitching (ON/OFF)
•
Determination of the area to be scanned
Use of automatic threshold specimen
•
Use of specimen threshold value
•
Use of Brightfield/Darkfield preview image
•
Use of marker pen threshold and specimen threshold values
•
Use of scan everything within marked area (ON/OFF)
•
Remove coverslip function (ON/OFF)
•
Filling of holes (ON/OFF)
•
September 16, 2020 – Rev. 1
Note:
3DHISTECH Ltd.
6 Using Profiles
135(156)