Agilent Technologies 5975 MSD Operation Manual page 123

5
6
7
8
9
Figure 22
5975/5977 Series MSD Operation Manual
Slide the signal wire from the connector in the sideplate.
Hold the new horn with the signal wire end down, and attach the signal
wire to the connector in the sideplate.
Slide the electron multiplier horn into position.
Close the retaining clip.
Close the rear analyzer chamber. (See
page 125.)
Retaining clip
Replacing the EM horn (Series 2 shown) Series 1 similar
General Maintenance
"To Close the Analyzer Chamber"
Electron multiplier horn
4
on
Blue signal wire
123