Grandstream Networks GVC3210 Administration Manual page 68

https://arttel.ru/
Use Configurations
of Config File
Server
Automatic Upgrade
Automatic Upgrade
Automatic Upgrade
Check Interval (Min)
Enable Randomized
Automatic Upgrade
Hour of the Day
(0-23)
Firmware Upgrade
and Configuration
file detection
Auto Upgrade
Without Prompt
Advanced Settings
Validate Server
Certificate
mDNS Override
Server
https://arttel.ru/shop/terminaly-vks/grandstream-gvc3210
If selected, the GVC3210 will download the cust file in the same way as retrieving
configuration file, i.e., same server and downloading mode, etc.
Enables automatic upgrade and provisioning. If set to "Check Every Day", "Check
Every Week" or "Check at a Period Time", fill in time interval below for upgrade. The
shortest time interval is 60 minutes. If set to "No", only upgrade when reboot the
device. The default setting is "Check Every Day".
Configures how the GVC3210 system will check the server for new firmware and
configuration file downloading. It's only valid if the user selects "Check at a period of
time" in the "Automatic Upgrade". Default setting is 10080 (namely 7 days).
Configures how the GVC3210 will check the server for new firmware and configuration
file downloading. It's only valid if the user selects "Check at a period of time" and
"check every week" in the "Automatic Upgrade". If enabled, GVC3210 upgrade
automatically at random time point in the setting period.
Defines the hour of the day (0-23) to check the TFTP, HTTP or HTTPS server for
firmware upgrade or configuration files changes. This option is available when
"Automatic Upgrade" is set to "Check Every Day ". The default setting is "1".
It is used to define the rules for automatic upgrade on the device.
It can be selected from the following:
 Always Check at bootup.
 Always Check at bootup, when F/W pre/suffix changes.
 Skip the Firmware Check.
The default setting is "Always Check at bootup".
It is used to set if the device will pop up a notification message before upgrading new
firmware. If set to "Yes", the device will automatically start upgrading after
downloading the firmware file. Otherwise, users would need to confirm in the prompted
message on the LCD screen to start upgrading process. Default is "Yes".
It is used to configure whether to validate the server certificate when download the
firmware/config file. If set to "Yes", the device will download the firmware/config file
only from the legitimate server. The default setting is "No".
It is used to set if the device will broadcast the Multicast DNS (mDNS) message during
booting up to allow itself to be discovered and be configured automatically. If it is set
to "User Type A', the device will broadcast the mDNS message "A_grandstream-
cfg.local"; if it is set to "Use Type SRV", the mDNS message will be
"SRV_grandstream-cfg.local". The default setting is "Use Type A".
GVC3210 Administration Guide
Version 1.0.1.21
P a g e | 68