Grandstream Networks GVC3210 Administration Manual page 58

https://arttel.ru/
DHCP VLAN
override
Host name
(Option 12)
Vendor Class ID
(Option 60)
DHCP Option 120
Override SIP
Server
IP Address
Subnet Mask
Default Router
DNS Server 1
DNS Server 2
PPPoE Account
PPPoE Password
802.1x Mode
802.1x Mode
https://arttel.ru/shop/terminaly-vks/grandstream-gvc3210

PPPoE: Configures PPPoE account/password. Obtain the IP address from the
PPPoE server via dialing.

Static IP: Manually configures IP Address, Subnet Mask, Default Router's IP
Address, DNS Server 1 and DNS Server 2.
DHCP Option 132 defines VLAN ID and DHCP Option 133 defines priority tag ID.
GVC3210 supports DHCP VLAN override via DHCP Option 132 and DHCP Option
133, or encapsulated DHCP Option 132 and DHCP Option 133 in DHCP Option 43.
Users could select "Disable", "DHCP Option 132 and DHCP Option 133", or
"Encapsulated in DHCP Option 43". By default, it is set to "Encapsulated in DHCP
Option 43":
 When set to "DHCP Option 132 and DHCP Option 133", the GVC3210 will get
DHCP Option 132 as VLAN ID and get DHCP Option 133 as VLAN priority, from the
DHCP server directly.
 When set to "Encapsulated in DHCP Option 43", the GVC3210 will get VLAN ID
and VLAN priority value from the DHCP Option 43 which has DHCP Option 132 and
DHCP Option 133 encapsulated. In this case, please make sure the option "Allow
DHCP Option 43 and Option 66 to Override Server" is enabled under GVC3210
webUIMaintenanceUpgrade.
It is used to configure the name of the client in the DHCP request. It is optional but
may be required by some Internet Service Providers.
It is used to configure the vendor class ID header in the DHCP request. The default
setting is "Grandstream GVC3210"
Enables DHCP Option 120 from local server to override the SIP Server on the device
when DHCP is used. The default setting is "Yes".
It is used to configure the device's static IP address if the static IP is used.
It is used to configure the network's subnet mask if the static IP is used.
It is used to configure the network's gateway address if the static IP is used.
It is used to configure the primary DNS IP address if the static IP is used.
It is used to configure the secondary DNS IP address if the static IP is used.
It is used to configure the PPPoE account ID if the PPPoE is used.
It is used to configure the PPPoE password if the PPPoE is used.
It is used to enable and select the 802.1x mode for the device. The default setting is
"Close". The supported 802.1x modes are:

EAP-MD5

EAP-TLS

EAP-PEAP
GVC3210 Administration Guide
Version 1.0.1.21
P a g e | 58