Table of Contents
Advertisement
6. Then press BACK until you return to
"Select Setup Option" screen and
select Manual.
7. Select Head 2, then select Side Tab.
8. Then select # Tabs, and on next screen,
select 2.
9. Select Pitch when "Select option to
edit" screen appears.
NOTE: Whether programming
manually or automatically you must
set pitch manually to ensure good
registration of the tab.
10. Pitch of tab is distance measured from
top of one tab to top of next tab. This is
done by selecting Pitch from "Select
option to edit" screen. Measure
distance from top of one tab to top of
next tab. In this case, it was 1.630".
Then add 0.01" for a total of 1.64".
Enter that number using Number keys on
Control Panel. Then press SAVE key.
PROGRAMMING THE TABBER
67
Advertisement
Table of Contents
