Table of Contents
Advertisement
3. Before setting up job, set up Tabber
Sensors to read stamp. Select V-Tab
and follow instructions.
4. Next screen allows you to select Head
you are using to tab. (This example
uses Head 1, so select V-Tab 1.)
5. To manually program V Tab
voltage: Begin by finding Gap V (or
voltage return from space between
Stamps in this case.) Release Hold
Down Roller Latch so stamps can
slide easily through Sensor. Move
Stamp web through Sensor until you
obtain lowest voltage reading , then
press Gap V key (1). Continue moving Stamp web through Sensor until you obtain
highest reading, then press Tab V key (2). When you are finished, press BACK key (3).
Tab Type
Description
Tabs in which space between tabs is lighter
Opaque
than tab even if tab is white.
Clear
Tabs that have a black line between tabs.
NOTE: When setting Gap Voltage and Tab Voltage manually, software determines if
Tab Type is Opaque or Clear based on voltage readings.
6. From "Select Setup Option" screen,
select Manual.
PROGRAMMING THE TABBER
Gap V Level
55
Tab V Level
Low
High
High
Low
Advertisement
Table of Contents
