Table of Contents
Advertisement
2. Lift Tab Drive Pressure Roller Release Latch on
Head 2 to release pressure between tab stock and
Tab Drive Roller.
3. Pull on backing until tab starts to protrude from
Applicator (peel point).
4. Lower Pressure Roller Release Latch.
NOTE: Image in Step 3 shows how center point of tab should align with exit end of Left
Media Guide Assembly. Please note that tab in this image is protruding further than
necessary. When initially adjusting tab starting point, tab should just start to protrude
from Applicator.
5. Close Exit Roller Assembly and lock two latches to secure it.
IF TABBER IS NOT PROGRAMMED FOR A TABBING JOB, REFER
TO "PROGRAMMING A JOB" SECTION FOR INSTRUCTIONS.
ONCE COMPLETE, RETURN TO THIS PROCEDURE.
IMPORTANT
27
OPERATING TABBER
Advertisement
Table of Contents
