Table of Contents
Advertisement
12. In this example we are going to apply
one stamp. Press 1.
13. Select Pitch when "Select option to
edit" screen appears.
NOTE: Whether programming
manually or automatically, set Pitch
manually to ensure good registration
of stamp.
14. Pitch of stamp is distance measured
from top of one stamp to top of next
stamp. This is done by selecting Pitch
from "Select option to edit" screen.
Measure distance from top of one
stamp to top of next stamp. In this
case it was 1.190". Then add 0.01" for
a total of 1.20". Enter that number using
Number keys on Control Panel, then press
SAVE key.
15. If only applying one stamp, "Select
option to edit" screen will reappear.
Press Position.
16. Next screen is used to position stamp
on piece. All measurements are taken
from lead or front end. In this case we
are placing stamp on trailing end of
piece. If piece is 10.5" long and we
wish to place stamp 1" from edge we
would enter 9.5" using Number keys
and then pressing SAVE key. Then
press BACK.
PROGRAMMING THE TABBER
57
Advertisement
Table of Contents
