Table of Contents
Advertisement
PROGRAMMING THE TABBER
FEEDER MODE SWITCH SHOULD BE SET TO MANUAL
4. Next screen allows you to select
Head you are using to tab.
(This example uses Head 2,
so select V-Tab 2.)
5. Next select Automatic from
"Tab Sensor 2 setup" screen.
6. "Select Tab before calibration"
screen appears. Select type of tab,
either Opaque or Clear, based on
table below.
(This example uses Opaque.)
7. When tab is selected, Tabber starts
and screen at right appears. Adjust
Speed Control on Tabber either up
or down until "Feed 1 Product
now" screen appears in display.
Press feed button on Feeder to feed
one piece. Tab Sensor is now set up
for this tab. Press BACK soft key
until "Select Setup Option" screen appears.
IMPORTANT
TAB TYPE
Tabs in which space between tabs is lighter
than tab even if tab is white.
Tabs that have a black line between tabs.
50
SELECT
Opaque
Clear
Advertisement
Table of Contents
