Table of Contents
Advertisement
OPERATING TABBER
2. Lift Tab Drive Pressure Roller Release Latch on
Head 1, to release pressure between tab stock and
Tab Drive Roller.
3. Loosen Head Stop and move it toward Head 2 to
permit moving Head 1 into position.
4. Pull on backing until a tab starts to protrude
from Applicator (peel point) into slot in
Center Plate.
5. Lower Pressure Roller Release Latch.
6. Refer to picture in Step 4 above and loosen
Head 1 Securing Knob, slide Head 1 over Right
Media Guide Assembly (as shown). Center tab
in slot in Media Support (as shown), and then
tighten Securing Knob.
NOTE: This image shows how center point of
tab should align with center of Media Support Plate. Note that tab in image is
protruding about the correct amount for end tabbing. Also note that a tab that is 1-1/2"
in diameter will not perfectly center on Assembly. It is important that tab backing
is against side of Tab Sensor Guide in all cases. Sensor position is where notch in Guide
is positioned.
22
Advertisement
Table of Contents
