Table of Contents
Advertisement
Install Optional Feeder
1. Pin [A] on Feeder should mate with hole
[B] on Tabber body.
2. When Feeder is properly aligned with Tabber body,
it looks like picture shown at right.
Connecting
Plugging in Feeder and Tabber
Make sure that Tabber Emergency Stop Switch is turned
OFF and Main Power Switch above Power Cord
Receptacle is turned OFF. Make sure that Power Switch
on Feeder is turned OFF.
1. Connect one end of Tabber power cord [1] to
rear of Tabber in corresponding receptacle.
2. Connect one end of Feeder power cord [2] to
rear of Feeder in corresponding receptacle.
3. Plug other cord ends into a 115 Volt AC (220
VAC International), 50/60 Hz, grounded outlet.
ASSEMBLY AND INSTALLATION
7
Advertisement
Table of Contents
