Table of Contents
Advertisement
OPERATING TABBER
3. Loosen Head Stop and move it toward Head 2 to
permit moving Head 1 into position.
4. Pull on backing until a tab starts to protrude
from Applicator (peel point).
5. Lower Pressure Roller Release Latch.
6. Refer to picture in Step 4 above, loosen Head 1
Securing Knob and slide Head 1 over Right
Media Guide Assembly (as shown). Center tab
on outer edge of Guide (as shown), and then
tighten Securing Knob.
NOTE: This image shows how center point of
tab should align with exit end of Right Media
Guide Assembly. Please note that tab in this
image is protruding further than necessary.
When initially adjusting tab starting point,
tab should just start to protrude from
Applicator. Also note that a tab that is 1-1/2" in diameter will not perfectly center
on the assembly. It is important that tab backing is against side of Tab Sensor Guide
in all cases. Sensor position is where notch in Guide is positioned.
7. Close Exit Roller Assembly and lock two latches to secure it.
20
Advertisement
Table of Contents
