ASTRO ATS-309 Operator's Manual page 15

2. Measure width of piece using
scale on Tabber. If media width
is less than 6.5", Center Support
Plate must be removed from
Tabber. This is done to allow
Right Media Guide to be
positioned closer to Left Media
Guide. (See "Narrow Media
Set-up" for more information.)
To remove Center Support Plate,
first remove Hold-down Guide,
then lift up on Center Support
Plate to remove it, (as shown).
CENTER SUPPORT PLATE AND HOLD-DOWN GUIDE MUST BE
INSTALLED WHEN USING MEDIA THAT MEASURES 6.5" OR WIDER.
FOR MEDIA LESS THAN 6.5" GO TO "NARROW MEDIA SET-UP" ON
PAGE 13.
3. Loosen securing knob for
Right Media Guide.
NOTE: Right Media Guide is movable.
Left Media Guide is fixed.
4. Turn ON Tabber's Main Power Switch.
Verify that Exit Roller Assembly is closed
and secured (lock latches). Verify that
Emergency Stop Button is released. Press
green Transport Power Button.
5. Press soft key labeled:
"Pass-Thru" to set Tabber
in Pass-Thru Mode.
NOTE: When Tabber is in
"Pass-Thru" mode it displays
"Press-Run for pass-thru
mode" and soft key changes to
"Operate".
IMPORTANT
11
OPERATING TABBER