Table of Contents
Advertisement
THIS EQUIPMENT PRESENTS NO PROBLEM WHEN USED PROPERLY. OBSERVE
SAFETY RULES WHEN OPERATING TABBER, LABELER, AND STAMP AFFIXER.
BEFORE USING TABBER, READ MANUAL CAREFULLY AND FOLLOW
RECOMMENDED PROCEDURES, SAFETY WARNINGS, AND INSTRUCTIONS:
Keep hands, hair, and clothing clear of rollers and other moving parts.
Avoid touching moving parts or materials while machine is in use. Before clearing a jam, be sure machine
mechanisms come to a stop.
Always turn machine off before making adjustments, cleaning, or performing any maintenance covered in
this manual.
Always use power cord supplied with the machine and plug it into a properly grounded, easily accessible
wall outlet located near the machine. Failure to properly ground the machine can result in
severe personal injury and/or fire.
Power cord and wall plug are primary means of disconnecting machine from power supply.
DO NOT use an adapter plug on line cord or wall outlet.
DO NOT remove ground pin from line cord.
DO NOT route power cord over sharp edges or trap it between furniture.
Avoid using wall outlets controlled by wall switches or shared with other equipment.
Make sure there is no strain on the power cord caused by jamming it between equipment, walls or furniture.
DO NOT remove covers. Covers enclose hazardous parts that should be accessed by a qualified service
representative. Report any cover damage to your service representative.
This machine requires periodic maintenance. Contact your authorized service representative for required
service schedules.
To prevent overheating, do not cover the vent openings.
Use this equipment only for its intended purpose.
In addition, follow any specific occupational safety and health standards for your workplace or area.
This manual is intended solely for the use and information of Astro Machine Corp., its designated agents,
customers, and their employees. The information in this guide was obtained from several different
sources that are deemed reliable by all industry standards. To the best of our knowledge, that information
is accurate in all respects. However, neither Astro Machine Corp. nor any of its agents or employees shall
be responsible for any inaccuracies contained herein.
All rights reserved. No part of this book may be reproduced or transmitted in any form or by any means, electronic or mechanical, including
photocopying, recording, or any information storage and retrieval system, without permission in writing from the publisher.
SAFETY PRECAUTIONS
Advertisement
Table of Contents
