Connecting Power - ASTRO ATS-9800 Operator's Manual

Connecting Power

1. The ATS-9800 is manufactured for use on a
specific AC voltage source. Before connecting
the power cord to the Tabber; verify that you
are connecting the unit to a compatible AC
voltage source. See serial tag for the voltage
rating of your unit.
2. Verify that the Power Switch is turned OFF
(0) position.
3. Plug the power cord, supplied, into the power
receptacle; as shown.
4. Plug the other end of the power cord into the
wall outlet.
5. To protect the unit from possible power line
surges or spikes; it is recommended that you
attach the Tabber to suitable surge/spike protector.
6. To replace the fuse, unplug the power cord from the Power Inlet, depress the tab on
the bottom of the Fuse Holder and remove the Fuse Holder. Replace the fuse and
return the Fuse Holder to the socket.
DO NOT USE AN ADAPTER PLUG OR EXTENSION CORD TO
CONNECT THE TABBER TO THE WALL RECEPTACLE.
DO NOT USE OUTLETS CONTROLLED BY WALL SWITCHES.
DO NOT USE AN OUTLET THAT SHARES THE SAME CIRCUIT
WITH LARGE ELECTRICAL MACHINES OR APPLIANCES.
CAUTION
SECTION 2
ASSEMBLY
15