1-Key Programming Using Key2Go - Directed Directechs DS4+ Installation Manual

1-Key programming using Key2GO

Important! Make sure all doors are closed on the vehicle before executing the programming sequence.
To connect the module:
Please ensure that the vehicle is in a safe location and cannot move forward during
1
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect all the harnesses to the DS4+, EXCEPT the 12-pin main power harness.
3
Connect the 12-pin main power harness, and wait until the LED turns ON solid red.
4
Insert the key and turn the ignition ON and OFF twice. The LED now flashes orange.
Remove the module from the vehicle and reconnect it to your computer. The Directechs
5
web site will automatically recognize that you are moving on to the second phase of the
programming sequence.
6
Select the method and click on Submit Key2GO Request
Once the configuration is completed, reconnect the unit to the vehicle. The LED then turns
7
ON solid green for 3 seconds once the module is successfully programmed.
Pair remotes (if applicable). For information on how to pair a specific remote, please
8
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
9
program tach, see page 63.
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
59
Key OUT
START
Key OUT
START
.
Must be
connected LAST
Key IN
2x
Key OUT
Key IN Key IN
START START
Key IN Key IN
START START
remotes*
Initialize
tachometer
© 2018-01-12 Directed. All rights reserved.
Connect all but the
12-pin harness
&
Solid
Key IN
&
Flashes
START
Orange
Key IN
START
Solid
x 3 secs
Pair
DS4+ FORD1