Mounting; Installation Notes - Bosch Rexroth IndraControl VDP 08.3 Manual

32/81 Bosch Rexroth AG
Dimensions, Installation and Wiring
5.2

Mounting

5.2.1

Installation Notes

Fig.5-8: VDP 40.3 DI, rear view
● The display is to be installed in such a way that an ergonomic operation
is ensured. Additionally, ensure that all machine components can be seen
by the operator!
● Avoid installation locations exposed to direct UV light/sunlight, as the
screen readability is reduced and additional heat development can occur.
● The LED displays on the front panel have to be visible.
● Lay all connecting cables in loops and use strain reliefs for all cables.
● Keep as much distance as possible to noise sources.
For maintaining the degree of protection IP 54, use only cable grommets that
fit to the cable cross-sections for cable bushing, see
Notes" on page 32.
Designation of the cable grommet (mount‐
ing/sealing kit)
QT4
QT5
QT6
QT7
QT8
DOK-SUPPL*-VDP*08.3***-PR02-EN-P
Rexroth IndraControl VDP 08.3/40.3 Operator Terminal
chapter 5.2.1 "Installation
Cable diameter
4-5 mm
5-6 mm
6-7 mm
7-8 mm
8-9 mm