Bosch Rexroth IndraControl VDP 08.3 Manual page 55

DOK-SUPPL*-VDP*08.3***-PR02-EN-P
Rexroth IndraControl VDP 08.3/40.3 Operator Terminal
Connector X2, X3
NOTICE
For terminal connectors use copper wire only. Tighten the screws of the screw
terminals with a torque of 2.25 lb in (0.25 Nm).
The X2 and X3 connectors are located behind the housing cover, see
7-14 "Connector X2, X3 on the VDP 40.3" on page
PIN 1
X3
Fig.7-14: Connector X2, X3 on the VDP 40.3
Bosch Rexroth AG
Destruction of screw terminals, insufficient
contact and loss of UL/CSA certification if no
copper wire is used and/or wrong tightening
torque.
53.
X2
53/81
Interfaces
fig.