Attachment To A Standardized Vesa Bracket - Bosch Rexroth IndraControl VDP 08.3 Manual

DOK-SUPPL*-VDP*08.3***-PR02-EN-P
Rexroth IndraControl VDP 08.3/40.3 Operator Terminal
5.2.3

Attachment to a Standardized VESA Bracket

Fig.5-14: Strain relief realized by a cable wrap
Using a blind grommet
Not used openings are to be covered with a blind grommet.
Fastening the cover
● Check that the seal of the cover is not damaged.
● Position the cover properly and fasten the screws with the corresponding
torque, see also fig. 5-15 "Mounting torques" on page
NOTICE
Do observe the minimum bending radius of the used cables.
Use suitable cable material (sufficient bending and torsional strength).
NOTICE
If screws were removed because of maintenance works, they have to be fas‐
tened again with the corresponding mounting torque, see the following table.
Threads
M2.5
M3
M4
M5
Fig.5-15: Mounting torques
Bosch Rexroth AG
Dimensions, Installation and Wiring
cable grommet
cable
cable wrap
Damage of cables due to wrong minimum
bending radius and use of unsuitable cable
material.
Damage of the mechanics caused by wrong
mounting torque.
Mounting torques
0.4 Nm
0.7 Nm
1.4 Nm
2.8 Nm
35/81
35.