Display Elements On The Y-Repeater; Leds On The Y-Repeater - Bosch Rexroth IndraControl VDP 08.3 Manual

DOK-SUPPL*-VDP*08.3***-PR02-EN-P
Rexroth IndraControl VDP 08.3/40.3 Operator Terminal
10.5

Display Elements on the Y-Repeater

10.5.1

LEDs on the Y-Repeater

NOTICE
For terminal connectors use copper wire only. Tighten the screws of the screw
terminals with a torque of 2.25 lb in (0.25 Nm).
Pin Labeling
1 24+
2 24-
3 SEL-
4 SEL+
Fig.10-11: Pin assignment X1S1
Input bit X1S1
0 (or open)
1
Fig.10-12: Selection of the active VDP
Connection method
Reverse voltage protection
Input voltage:
Nominal value for "0"
Nominal value for "1"
Input current:
Nominal value for "0"
Nominal value for "1"
Cable length (unshielded)
Short-circuit protection, overcurrent pro‐
tection
Fig.10-13: Characteristic values of the digital 24 V input
NOTICE
The power LED permanently lights on an active operator display.
The power LED flashes on an inactive operator display.
There are five LEDs on the Y-repeater:
Bosch Rexroth AG
Destruction of screw terminals, insufficient
contact and loss of UL/CSA certificiation if no
copper wire is used and/or wrong tightening
torque.
Function
Supply voltage 24 V
Supply voltage 0 V
Changeover input 0 V
Changeover input 24 V
Active VDP
VDP 08.3/40.3 no. 1 (XVID1, XSER1)
VDP 08.3/40.3 no. 2 (XVID2, XSER2)
2-wire connection
Yes
-3 V to 15 V
18 V to 30 V
< 2.5 mA
2.8 mA to 6 mA
< 100 m
Typ. 0.6 A
No operation possible at the VDP if the power
LED flashes.
65/81
Y-Repeater