Table of Contents
Advertisement
D7212GV2 | Operation and Installation Guide | 4.0
4.0 Installation
4.1
Installation Preparation
This section contains a general installation procedure
and refers to other sections of the document for
detailed instructions.
Review this document and the D7212GV2 Program
Entry Guide (P/N: F01U003804) before beginning the
installation to determine the hardware and wiring
requirements for the features used.
Have the following documentation available when
reading through this guide:
•
D7212GV2 Program Record Sheet (P/N:
F01U003803)
•
Security System Owner's Manual (P/N: 71-06633-000)
and Security System Owner's Manual Supplement
(P/N: 33267)
•
Command center (keypad) installation manual
(D1255, D1256, D1257, D1260, or D720)
Before installation, become familiar with the operation
of the D5200 Programmer or the RPS.
Figure 2:
Enclosure Mounting
1
1 - Point chart label
2 - Mounting skirt hooks (2)
3 - Module mounting holes (12)
4 - Tamper switch mounting holes (5)
5 - Skirt mounting hole (1)
14
Installation
4.2
Mount the control panel assembly in any of the Bosch
Security Systems enclosures listed:
•
•
Refer to the D7212GV2 Approved Applications Compliance
Guide (P/N: F01U003806) to determine if the
application requires a specific enclosure.
4.3
1. Run the necessary wiring throughout the premises.
2. Mount the enclosure in the desired location. Use
3. Pull the wires into the enclosure.
Electro-Magnetic Interference (EMI) can cause
problems on long wire runs. Refer to EMI on Long Wire
Runs in the D9412GV2/D7412GV2/D7212GV2
Installation and Troubleshooting Quick Reference Guide
(P/N: F01U003638).
3
2
5
6
6-
7 - Mounting skirt hook holes (2)
8 - Back of D7212GV2 Control Panel
9 - Lock down tab
Enclosure Options
D8103 Universal Enclosure (tan)
D8108A Attack Resistant Enclosure (tan)
Mounting Enclosure
all five enclosure mounting holes. Refer to Figure 2.
2
4
3
Enclosure mounting holes (5)
Bosch Security Systems, Inc. | 5/05 | F01U003805B
7
8
9
Advertisement
Table of Contents
