Queue Management - Zte ZXHN H298N Maintenance Manual

Parameter
Source Port MIN/MAX
Destination Port MIN/MAX
DSCP
Source IP Address MIN/MAX
Destination IP Address MIN/MAX
802.1p Re-marking
DSCP Re-marking
CAR Index
Queue Index
3. Click Add.
The QoS classification rules are configured.

6.8.3 Queue Management

Prerequisite
Before this operation, make sure that the basic
management is enabled.
Description
Range: 0–65535
Range: 0–65535
Range: 0–63
Source IPv4 address range of the matched data flow
Destination IPv4 address range of the matched data flow
To modify the 802.1p field value when the packet is sent
from the WAN side.
If the data flow that matches the classification rule is sent
to the CPE, this parameter does not take effect.
Range: 0–7
To modify the DSCP field value when the packet is sent
from the WAN side.
If the data flow that matches the classification rule is sent
to the CPE, this parameter does not take effect.
Range: 0–63
To limit the ingress rate for the data flow.
Set the value range on Rule Number in Committed
Access Rate.
To perform the queue rule processing when the packet is
sent from the WAN.
The content of the parameter is displayed as "queue
rule ID&device name&queue priority". For example,
"Key1&eth0&Prio1" indicates to process the packet that
match the classification rule in the first-priority queue on
the eth0 device. If this packet is not sent from the eth0
device at last (this may occur on the ADSL uplink), this
packet is processed in the default queue on the current
device.
QoS configuration is complete and the queue
103