Status Messages And Suggested Actions; System Status Messages - Domino F Series Product Manual

STATUS MESSAGES AND SUGGESTED
ACTIONS
The F-Series will display messages in the control unit display. The
messages are listed in the following tables with actions where appropriate:

System Status Messages

Status Message
1 No
communication
with DSP.
2 Failed to start
controller
system.
3 DSP watchdog
fault.
4 Laser watchdog
fault
5 Print go while
printing.
6 Encoder loop:
Period too small.
7 Print go while
DSP data not
ready.
8 Print go while
DSP data not
ready
EPT009665 Issue 2 May 2015
MAINTENANCE AND FAULT FINDING
Cause
No response from
the DSP part of the
control system
during running.
DSP Initialisation
failed.
The SBC did not
respond to a DSP
request.
The laser has been
firing for longer than
expected.
A print go trigger has
been received while
the laser is busy
printing.
Encoder based
continuous printing
feature generates the
next print while the
previous print is not
finished.
There is no valid data
in the DSP when a
print go is received.
A new print is
currently being
compiled and no
print start can be
issued until the
printer is ready
again.
Suggested Action
Turn off the controller. Check
boards are all connected,
restore backup, restart the
controller.
Turn off the controller. Check
boards are all connected,
restore backup, restart the
controller.
Turn off the controller. Check
boards are all connected,
restore backup, restart the
controller.
Contact Domino.
Check that the print go signal
does not have switch bounce,
check the time taken to print
vs the print repeat time.
Reduce the print distance or
reduce width of the message.
Make sure the printer is ready
before generating a print go.
Switch off 'Force Recompile'
after print.
Monitor 'compile OK' line high
when data compiled and
make sure that you don't
trigger a print before it is high
again after a data change.
5-7