Product Distance And Print Start - Ignore Distance - Domino F Series Product Manual

INSTALLATION INSTRUCTIONS
Product Distance and Print Start - Ignore
Distance
With this special feature it is possible to set a minimum and maximum
distance between two products to mark.
Login as administrator and navigate to:
Home > Settings > Production Line Setup > Line Movement > Product
Distance
Setup the "Maximum Distance" and/or the "Print Start Ignore Distance" in
millimetres.
Both options are deactivated by setting the distance to 0.00 mm.
To activate one or both options enter a distance.
If "Maximum Distance" is exceeded by passing products between
two print start signals an error message is displayed: "Maximum print
to print distance exceed". The error ID is 14. The system is not any
longer ready for printing.
If "Print Start Ignore Distance" is under-run by passing products
between two print start signals a warning message is displayed:
"Print start signal ignored". The error ID is 15. The second print start
signal is ignored and does not lead to a print on the product. A
possible "Print Start while Printing" error is suppressed.
EPT009665 Issue 2 May 2015 2-63