The F220i controller cabinet contains
• The laser source
• The controller board for shutter and laser
• A specially programmed safety relay
• A power supply for controlling the shutter and laser.
Supplied functions:
• Data transfer between BCP controller and the laser source
• Shutter controlling (only with shutter option)
As standard, every opening of the safety guard will switch off the laser
PSU.
USB 1.1 Port
The USB 1.1 ports are located on the top right hand side of the front of the
control unit.
Ethernet connections
There
are
two
pre-configured for access via the IP address 192.168.58.2 / subnet mask
255.255.255.0. The connector is a RJ45 Bulgin connector.
Ethernet 2 connection (X59) is pre-configured for plug and play connection
of the optional Touchpanel. The IP address is 192.168.57.2 / subnet mask
255.255.255.0.
EPT009665 Issue 2 May 2015
INSTALLATION INSTRUCTIONS
Ethernet
connections.
Ethernet
1
connection
is
2-13