Touchpanel - Domino F Series Product Manual

TOUCHPANEL

The installation must be carried out by trained technicians only.
Two supply voltages are provided for the TouchPanel which can be
operated individually or in parallel:
AC Mains supply via mains
socket
• Mains supply via the main socket. Only use the Domino power cord
VEY1414.
CAUTION:
• The built-in power supply may be switched via the AC On/Off switch
on the TouchPanel.
• Power supply via the X59 ethernet connector of the BCP7 controller.
Only use the Domino X59 cables with 5m (Domino part number
L015211) or 10m (Domino part number L015212) length to connect the
TouchPanel to the BCP7 controller. Only these cables ensure the 24V
DC power supply of the TouchPanel. The power supply of the
TouchPanel fused with 2.5A inside the BCP7 controller. This power
supply may only switched off with the BCP7 controller
switch.
EPT009665 Issue 2 May 2015
INSTALLATION INSTRUCTIONS
AC On/Off
Switch
A free accessible power socket must be installed
nearby the TouchPanel. Extension cables must not
be used to connect the TouchPanel to mains power.
Power supply via BCP7
controller (X59)
On/Off
2-9