To Use Digital Leads (For Vs5000D Only) - Rigol VS5000 Series User Manual

To Use Digital Leads (for VS5000D only)

1. Switch off power supply of the Device under Test if necessary to avoid short
circuit. Since no voltage is applied to the leads at this step, the oscilloscope may
remain on.
2. Connect one end of the flex cable FC1868 to the Logic Analyzer Input; connect
the other end to Logic Head LH1116. It is unnecessary to switch off power supply
of the oscilloscope while connecting the cable.
CAUTION：Use only FC1868, LH1116, TC1100 and LC1150 made by
!
1-12
Figure 1-10
Connect the Flex Cable
RIGOL for specified mixed signal oscilloscopes.
User's Guide for VS5000 Series
© 2008 RIGOL Technologies, Inc