Table of Contents
Advertisement
RIGOL
Chapter 2 Operating Your Oscilloscope
The VERTICAL, HORIZONTAL, and TRIGGER control systems and know how to
determine the system setup from the status bar of a VS5000 Series oscilloscope were
introduced in the previous chapter.
This chapter will go through all groups of buttons, knobs, and menus, expanding the
knowledge of operations by hints in this guide.
It is recommended to perform all of the following exercises to get the most of the
powerful measurement capabilities of the oscilloscope.
Understand the vertical system
Understand the horizontal system
Understand the trigger system
To set up the sampling system
To set up the display system
To load、save and print
To set up utility
To measure the waveform
To use the run control buttons
[1] NOTE: This function is for VS5000D model only.
In order to get more information about the various measurements and operations of
VS5000, please read this chapter carefully.
© 2008 RIGOL Technologies, Inc.
(
,
,
( Horizontal )
( Trigger )
( Acquire )
( Display )
( Storage )
( Utility )
( Analyzer )
(
,
User's Guide for VS5000 Series
, Vertical )
[1]
and
)
2-1
Advertisement
Table of Contents
