Rigol VS5000 Series User Manual page 98

To Measure with Cursor Measurements
Click the Cursor button in the Analyze menu to select the Cursor functions.
Cursor
measurement
The Cursor measurement has three modes: Auto Measure, Manual and Track.
Auto Measure:
This mode will take effect with Automatic Measurements. The instruments will
display cursors while measuring parameters automatically. These cursors
demonstrate the physical meanings of these measurements.
Manual:
In this mode, the screen displays two parallel cursors. Move the cursors to make
custom voltage or time measurements of the signal. The values are displayed on the
boxes below the menu. Before using cursors, make sure that to set the Signal Source
as the channel for measuring.
Track:
In this mode, the screen displays two cross cursors. The cross cursor sets the
position on the waveform automatically. Adjust the horizontal position of cursor on
the waveform by click the
oscilloscope displays the values of the coordinates on the boxes below the menu.
NOTE: The Auto Measure mode for Cursor measuring will take no effect without
automatic measurements.
2-66
Figure 2-44
Choose the Menu of Cursor Measurement
button or drag the cursor on the screen. The
User's Guide for VS5000 Series
© 2008 RIGOL Technologies, Inc