Installing The Vga Module - Dell EMC XC Core XC450 Installation And Service Manual

Steps
1. Using Phillips #1 screwdriver, remove the screw on the VGA module.
2. Slide the module out of the system.
Figure 84. Removing the VGA module
Next steps
Replace the VGA module.

Installing the VGA module

Prerequisites
1. Follow the safety guidelines in
2. Follow the safety guidelines listed in
3. Remove the front bezel.
4. Remove the backplane
5. Remove the air shroud.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Route the VGA cable through the VGA module slot on the front of the system and slide the VGA module into the slot.
2. Align the hole on the module with the screw hole on the system.
3. Using the Phillips #1 screwdriver, secure the VGA module to the system with the screw.
Safety instructions.
Before working inside your
cover.
system.
Installing and removing system components 79