Installing The Drive Into The Drive Carrier - Dell EMC XC Core XC450 Installation And Service Manual

Figure 31. Removing the drive from the drive carrier
Next steps
Install the drive into the drive

Installing the drive into the drive carrier

Prerequisites
Follow the safety guidelines listed in the
NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to install the drive.
38 Installing and removing system components
carrier.
Safety instructions