Control Panel; Removing The Left Control Panel - Dell EMC XC Core XC450 Installation And Service Manual

Control panel

This is a service technician replaceable part only.

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
4. If applicable, remove the backplane
Steps
1. Disconnect the control panel cable from the system board connector.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Open the cable retention latch.
3. Remove the cable from cable clip.
4. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel assembly to the system.
5. Hold the left control panel assembly and remove the control panel along with the cable from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 93. Removing the left control panel
Next steps
Replace the left control panel.
Safety instructions.
Before working inside your
cover.
system.
Installing and removing system components 89