Optional Ocp Card; Removing The Ocp Card - Dell EMC XC Core XC450 Installation And Service Manual

3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the M.2 BOSS card with the screw.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 77. Installing the M.2 SSD module
Next steps
1. If applicable, install the M.2 BOSS card into the M.2 BOSS
2. If applicable, Install the M.2 BOSS
3. Follow the procedure listed in the

Optional OCP card

Removing the OCP card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the expansion card
Steps
1. Open the blue latch to unlock the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
riser.
After working inside your
Safety instructions.
Before working inside your
riser.
riser.
system.
system.
Installing and removing system components 73