Drives; Removing A Drive Blank - Dell EMC XC Core XC450 Installation And Service Manual

Steps
1. Align and insert the intrusion switch module until it is firmly seated in the slot on the system.
2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the system board.
NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Figure 26. Installing the intrusion switch
Next steps
1. Replace the air shroud.
2. Follow the procedure listed in

Drives

Removing a drive blank

Prerequisites
1. Follow the safety guidelines in
2. If installed, Remove the front
CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
Steps
Press the release button, and slide the drive blank out of the drive slot.
34 Installing and removing system components
After working inside your
Safety instructions.
bezel.
system.